3D Rose Sucker Chocolate Mold
Country Kitchen SweetArt Facebook
Share via PInterest
Country Kitchen SweetArt Twitter Share
Share via email
print page

3D Rose Sucker Chocolate Mold

Brand:CK Products

Units: 1 Dimensions: 4 cavities: 2" wide x 2¼" long x 1" deep
4 cavities per mold. Approximately 13 solid pieces can be obtained from a pound of candy coating or chocolate. Create a 3D rose made of chocolate! Lay sucker stick in mold and make sure that chocolate is spread over the back of the stick in the rose. To adhere the other half of the rose, do not freeze the candy. Let it set up at room temperature. When you are ready to assemble, run the free half on a warm cookie sheet and press against the first half. Or keep melted chocolate or candy coating on hand to act as a glue between the two halves. The sucker stick can be covered in floral tape to complete the look.
If you make the pieces without adding the sucker sticks, each half can fit into the box shown.
Hand wash only. *This type of plastic is perfect for chocolate and coatings, but is not designed for hard candy or other hot ingredients.
Additional Details

allergy warning
heat warning
flat rate Free Shipping on orders $60 and over.